We are going to be using an amplitude of 3 V. So let's go and turn on the single sweep. I am going to create a single sweep sine wave that's going to be looking at a range of frequencies across the circuit, hoping to find the resonating frequency for the LRC setup somewhere approximately in the middle of my time range. So I am going to click on my Signal Generator, and I will be using Output 1. I am now ready to go set up my signal generator. So I am going to add my two Voltage Sensors.
I can do that by clicking on the channel, typing the first few letters of the sensor, and then confirming it with the Enter button. I am going to begin by going to my Hardware Setup and adding my two Voltage Sensors. Now let's take a look PASCO Capstone and getting set up inside of our software. PASCO Capstone is the next leap forward in software for data acquisition, display and analysis and destined to be the new standard in advanced physics and engineering.Īnd my signal generator is attached across the entire circuit. In Channel B, I have a Voltage Sensor measuring the voltage across my second resistor. Connected to my 850 interface, in Channel A I have a Voltage Sensor measuring the voltage across the entire circuit. On the circuit board I am going to be using the first inductor component, the first capacitor component, and the second resistor component. I am going to be using the UI-5210 circuit board. Let's begin by taking a look at our LRC circuit setup. In this video, we are going to take a look at an LRC setup with PASCO Capstone and the 850 Universal Interface.
0 kommentar(er)
